Start-up and Inrush Current
In order to facilitate quick startup, a soft-start circuit

is not incorporated into the ACT6311. When the IC

is first turned on with no external soft-start circuit,
the peak inrush current is about 400mA. Figure 8
shows an implementation for soft-start. When
soft-start and dimming controls are used
simultaneously, a low frequency PWM signal (less
than 10kHz) or the methods in Figures 5, 6 and 7
should be used.
Open-Circuit Protection (White LEDs)
If one of the LEDs is disconnected, the FB voltage
drops to zero and the IC switches at maximum duty
cycle. This results in a high voltage that may
exceed the SW voltage rating. To limit this voltage,
use a Zener diode as shown in Figure 9. The Zener
voltage must be large than the total forward voltage
of the LEDs and the current rating should be higher
than 0.1mA.
Board Layout
To reduce EMI, minimize the area and path length
of all traces connected to SW. Use a ground plane
under the switching regulator and connect R1
directly to the G pin of the IC.

企业名：深圳市维讯瑞科技有限公司

类型：贸易/代理/分销

电话： 15989733600
15989733600

手机：15989733600
15989733600

联系人：少滨/少滨

QQ：

邮箱：569805151@qq.com

地址：广东深圳深圳市福田区华强北街道华强广场D座15G，公司可做13点增值税！