一．电器性能规格　ＥLE*RICAL CHARA*ERISTICS

测试条件 Test Conditions

在微小电流(100mA )以下测试

Measured at *all l current (100mA or less) 1000HZ

输入500V电压1分钟,按以下方式测试:Apply a voltage of 250V DC for 1 min to following portions after mhich measurement shall be made:

(1) 塑胶体与针脚之间 (1)Between body and conductor

(2) 不接触的针脚之间 (2)Between conductor not to be contact

输入AC500V(50-60HZ)电压,1分钟感应电流为0.5MA,按以下方法测试:

AC 250V ims(50-60HZ) for 1 min trip current: 0.5 mA

(1)塑胶体与排脚之间 (1)Between terminals

(2)不接触的排脚之间: (2)Between individual terminals and frame

-25℃----+75℃

在没有指定的情况下测试温度,湿度,气压如下:

Unless otherwise specified , the stardard range or atmospheric conditions for making measurements and tests are as follows

(1) 温度为5℃--35℃ (1)Ambient temperature:5℃to 35℃

(2) 湿度为45%--85% (2)Relative humidity :45% to 85%

(3) 气压为80KPA----106KPA (3)Air pressure : 80Kpa to 106Kpa

二.机械性能规格 MECHANICAL CHARA*ERISTICS

在排脚前端任意一个方向的先端加上300克力力度测试，时间为15秒

A static load of 300gf shall be applied to the tip of the terminal for 15 sec in any direction

负荷：在负荷的条件下以每分钟25-30回的频率进行100,000次的负荷测试;

Aswitch shall be subjected to 100.000 cycles at a speed of 25-30 cycles for 1 min